Installation Guide

Installation Guide

IrisShift is plug & play. Most builders finish in an afternoon with basic hand tools.

1. Check your lenses. IrisShift fits vehicles with replaceable 3-inch projector lenses. Confirm yours before you start.
2. Access the headlight. Remove the headlight housing following your vehicle's service steps.
3. Fit the projectors. Seat the two RGB demon eye projectors behind your lenses — no cutting, no coding.
4. Wire the module. Connect the control module to a 12V source and tidy the wiring.
5. Test & pick a mode. Reassemble, power on, and cycle through all 33 modes with the wireless remote.

Stuck? Email info@irisshift.store or DM @theirisshift — we reply within 24 hours.

IrisShift is designed for meets, shows and off-road use. Check your local laws before using it on public roads.